Tube2

[maty-sk]

Tube2

Save hours by automatically having the quickest routes to hand, with all the details you need including line changes, platform directions and accurate journey times.

No more confusion on your trips, route details include, direction of travel, end of line, towards information, and number of stops in each segment. Select advanced journey options such as quickest journey, fewest stops, avoid lines and quickly display return journey details.


Requirements:
Symbian UIQ3 phone ( e.g. Sony Ericsson M600i/P990/W950/P1i).
Storage card install supported.

There is a crack circulating in the web using a hex editor:
1. First download the free tube engine
2. Then find the maps you want: _http://www.visualit.co.uk/UIQ3/UIQ3_Tube2.htm
3. Download any of the trial versions.
4. Next install the engine and the map on to your phone (necessarily on the memory card)
5. Now either using a memory card reader or the phone in File Transfer Mode. Find Media filesOtherTube 2 maps[mapname].vmp (not the O.vmp version) and open it with a Hex Editor.
6. Get right to the end of the file, and you should see either 4 random numbers (xxxx), 8 with a dot in the middle (xxxx.xxxx) or even 12 with two dots (xxxx.xxxx.xxxx).
7. Change these to digits to 0 (eg 0000 or 0000.0000 or 0000.0000.0000)
8. Now open the Tube 2 application.
9. Select the map.
10. If it will ask you to register, enter activation code 00000.

tested on mine w960 works great

[tommynguyen1961]

thanks so much

[elk]

Doesnt seems to work with the map of Berlin, Germany...
At my fon, I found 8 numbers, seperated with a , not a .
Changed it to Zero, but the code doesnt works...

[maty-sk]

Hi just dowloaded Berlnin map,Changed all to 0000 Tested and it works fine for me. Are the other maps working??Make sure That you folow the instructions corectly.

[Mr.Bombastic]

Maty are you from Slovakia??? Ked ano tak by som sa ta chcel spytat ci tam je aj mapa slovenska a si aj na fore mobilmania.cz????

[elk]

Hi maty,
could you post the last few lines of the file in original and changed version? Just to complain...

[elk]

!þVITPNS,3715,3333 ;

These are the last characters in my file.

I changed it to

!þVITPNS,3715,0000 ;

and

!þVITPNS,0000,0000 ;

and both doesnt works...

[maty-sk]

If this was your original/ !þVITPNS,3715,3333 ;/ and you changed that to /!þVITPNS,0000,0000 ;/ with hex editor it should work corectly. Make sure you following instructions from the top of page cerrecly and you edited only the file with /.wmp/ at the end and saved the changes after editing.hope helps you.

[elk]

Thanks a lot. I did a third time and now it works!